This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howtos:admin:install_and_administer_a_virtual_machine_vm [2010/02/08 16:29] shona.weldon |
howtos:admin:install_and_administer_a_virtual_machine_vm [2012/03/09 14:07] shona.weldon |
||
---|---|---|---|
Line 18: | Line 18: | ||
* Take note of the ip address (you'll need it for the next steps in host only mode) | * Take note of the ip address (you'll need it for the next steps in host only mode) | ||
* Go to the devices tab, double click the eth0 | * Go to the devices tab, double click the eth0 | ||
- | * Record the static ip address, probably something like: 192.68.80.200 | + | * Record the static ip address, probably something like: 192.168.80.200 |
* Logout and reboot the machine | * Logout and reboot the machine | ||
Line 24: | Line 24: | ||
How to get it into nat mode: | How to get it into nat mode: | ||
* Make the VMnet8 network connection configuration use DHCP to obtain addres | * Make the VMnet8 network connection configuration use DHCP to obtain addres | ||
- | * Set the Devices/Network Adaptor on the VM to NAT | + | * Set the Devices/Network Adaptor on the VM to NAT in the "Settings" of the outer shell of the VM Player |
* In the networking of the VM setup the IP address to come from DHCP | * In the networking of the VM setup the IP address to come from DHCP | ||
* Uncheck the "Automatically obtain DNS information from provider | * Uncheck the "Automatically obtain DNS information from provider | ||
Line 43: | Line 43: | ||
then choose "Network and Sharing Center" and look in the "View your active networks" section of the page | then choose "Network and Sharing Center" and look in the "View your active networks" section of the page | ||
- | === On either system: === | + | === On either system continue with: === |
* Choose VMNet1 for host only mode (VMnet8 for NAT mode) connection and look at the properties (right click properties) | * Choose VMNet1 for host only mode (VMnet8 for NAT mode) connection and look at the properties (right click properties) | ||
* If you intend to use VMnet1 (which is the default) disable VMnet8 | * If you intend to use VMnet1 (which is the default) disable VMnet8 | ||
- | * Double click "Internet Protocol (TCP/IP)" | + | * Double click "Internet Protocol (TCP/IP)" (on Vista and windows 7 choose TCP/IPv4) |
* Make sure the first 3 parts of the ip address match that of your VM but not the last | * Make sure the first 3 parts of the ip address match that of your VM but not the last | ||
* If VM is in host only mode adjust the host side here (use this option by default) | * If VM is in host only mode adjust the host side here (use this option by default) |