This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
howtos:typicalerrors [2011/04/03 13:06] shona.weldon created |
howtos:typicalerrors [2011/04/21 16:09] chris.strashok |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Typical errors and solutions ====== | ====== Typical errors and solutions ====== | ||
+ | ===== Calibration framework load error ===== | ||
+ | When you see the following message, | ||
+ | |||
+ | {{:howtos:model_loading_error_1.jpg|}} | ||
+ | |||
+ | the variables between the calibrator and the simulation are not linked up properly. This is usually caused when the name of a variable is changed in the calibrator and is not updated in the simulator. | ||
+ | |||
+ | Ensure that the names of the variables entering the simulator diagram from the calibrator are the same. Also ensure that the simulator variable is bound to the correct calibrator variable by examining the History tab in the Variable Information view. | ||
+ | |||
===== seek error when saving first sim scenario ===== | ===== seek error when saving first sim scenario ===== | ||
Here's a screenshot of the type of error message you may see: | Here's a screenshot of the type of error message you may see: |