howtos:typicalerrors
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
howtos:typicalerrors [2011/04/21 16:09] chris.strashok |
howtos:typicalerrors [2011/06/15 21:15] chris.strashok |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| * check the .v file for the calculator to make sure the variable is marked correctly as an input | * check the .v file for the calculator to make sure the variable is marked correctly as an input | ||
| * make sure that it is an output in the calibrator mapping to the input in the simulator | * make sure that it is an output in the calibrator mapping to the input in the simulator | ||
| + | |||
| + | ===== dimensional analysis tool error ===== | ||
| + | |||
| + | When you see the following message in the Documenter TOOL console, | ||
| + | |||
| + | **= tool: Can't open file: ink** \\ | ||
| + | **TOOL: execution error** | ||
| + | |||
| + | you are trying to run the calculators backwards when there is no calibrator structure in place. | ||
| + | |||
| + | Remember you do not need to run the calculators backwards when you have a simulation framework on its own or for the calibration framework. | ||
howtos/typicalerrors.txt ยท Last modified: 2011/08/30 18:28 by marcus.williams
Page Tools
