This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howtos:typicalerrors [2011/04/21 16:09] chris.strashok |
howtos:typicalerrors [2011/06/16 13:37] marcus.williams |
||
---|---|---|---|
Line 20: | Line 20: | ||
* check the .v file for the calculator to make sure the variable is marked correctly as an input | * check the .v file for the calculator to make sure the variable is marked correctly as an input | ||
* make sure that it is an output in the calibrator mapping to the input in the simulator | * make sure that it is an output in the calibrator mapping to the input in the simulator | ||
+ | |||
+ | ===== dimensional analysis tool error ===== | ||
+ | |||
+ | TOOL error during dimensional analysis: | ||
+ | |||
+ | <file> | ||
+ | = tool: Can't open file: ink | ||
+ | TOOL: execution error | ||
+ | </file> | ||
+ | |||
+ | Possible cause: | ||
+ | |||
+ | You are trying to run dimensional analysis backwards when there is no calibrator structure in place. | ||
+ | |||
+ | Remember you do not need to run the calculators backwards when you have a simulation framework on its own, or for the calibration framework. |