This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howtos:typicalerrors [2011/06/15 21:15] chris.strashok |
howtos:typicalerrors [2011/06/16 15:39] marcus.williams |
||
---|---|---|---|
Line 23: | Line 23: | ||
===== dimensional analysis tool error ===== | ===== dimensional analysis tool error ===== | ||
- | When you see the following message in the Documenter TOOL console, | + | TOOL error during dimensional analysis: |
- | **= tool: Can't open file: ink** \\ | + | <file> |
- | **TOOL: execution error** | + | = tool: Can't open file: ink |
+ | TOOL: execution error | ||
+ | </file> | ||
- | you are trying to run the calculators backwards when there is no calibrator structure in place. | + | <code> |
+ | = tool: Can't open file: ink | ||
+ | TOOL: execution error | ||
+ | </code> | ||
- | Remember you do not need to run the calculators backwards when you have a simulation framework on its own or for the calibration framework. | + | Possible cause: |
+ | |||
+ | You are trying to run dimensional analysis backwards when there is no calibrator structure in place. | ||
+ | |||
+ | Remember you do not need to run the calculators backwards when you have a simulation framework on its own, or for the calibration framework. |