whatIf? Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Steps for Creating a Calibration Diagram ======

Steps for creating a calibration framework:
  - Prepare the simulation diagram
    - Initialize variable history links in simulator - in the hierarchy tree or one calculator at a time right click and choose "Set History Links..."
    - Adjust the history indexes by replacing simulation (time dependent) informants with calibration ones (e.g. ts with th)
    - Handle binding link rules by setting them appropriately on the history tab
  - Copy simulator diagram (that runs dimensional analysis successfully); rename to cal; change framework properties and directories
  - Modify the simulation calculators in the calibration diagrams for running over history
    - If any //if $history// clauses are used in the procedure boxes, preserve logic from the //true// branches and remove the //else// logic from the images in the calibrator. See [[howtos:Selective calibration - excluding some of a simulator from calibration]]
    - Replace simulation (time dependent) informants with calibration ones (e.g. ts with th) in the calibration diagram.
  - Create calibration calculators
    - In the hierarchy diagram highlight the simulation calculators, right click and choose "Create Calibrator Calculator"
  - Fill in all the calibration calculators to manipulate input data for the calibrator
  - Run dimensional analysis in calibrator.

whatIf? Wiki

User Tools

Site Tools

Page Tools