howtos:typicalerrors
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
howtos:typicalerrors [2011/04/21 16:09] chris.strashok |
howtos:typicalerrors [2011/06/16 15:40] marcus.williams |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| * check the .v file for the calculator to make sure the variable is marked correctly as an input | * check the .v file for the calculator to make sure the variable is marked correctly as an input | ||
| * make sure that it is an output in the calibrator mapping to the input in the simulator | * make sure that it is an output in the calibrator mapping to the input in the simulator | ||
| + | |||
| + | ===== dimensional analysis tool error ===== | ||
| + | |||
| + | TOOL error during dimensional analysis: | ||
| + | |||
| + | <file> | ||
| + | = tool: Can't open file: ink | ||
| + | TOOL: execution error | ||
| + | </file> | ||
| + | |||
| + | Possible cause: | ||
| + | |||
| + | You are trying to run dimensional analysis backwards when there is no calibrator structure in place. | ||
| + | |||
| + | Remember you do not need to run the calculators backwards when you have a simulation framework on its own, or for the calibration framework. | ||
howtos/typicalerrors.txt ยท Last modified: 2011/08/30 18:28 by marcus.williams
Page Tools
