creating_a_calibration_diagram
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
creating_a_calibration_diagram [2010/11/12 16:10] marcus.williams |
creating_a_calibration_diagram [2010/11/12 16:12] (current) marcus.williams |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| - Adjust the history indexes by replacing simulation (time dependent) informants with calibration ones (e.g. ts with th) | - Adjust the history indexes by replacing simulation (time dependent) informants with calibration ones (e.g. ts with th) | ||
| - Handle binding link rules by setting them appropriately on the history tab | - Handle binding link rules by setting them appropriately on the history tab | ||
| - | - Copy simulator diagram (that runs dimensional analysis successfully); rename to cal; change [[|framework properties and directories]] | + | - Copy simulator diagram (that runs dimensional analysis successfully); rename to cal; change [[Framework Information Settings|framework properties and directories]] |
| - Modify the simulation calculators in the calibration diagrams for running over history | - Modify the simulation calculators in the calibration diagrams for running over history | ||
| - If any //if $history// clauses are used in the procedure boxes, preserve logic from the //true// branches and remove the //else// logic from the images in the calibrator. See [[howtos:Selective calibration - excluding some of a simulator from calibration]] | - If any //if $history// clauses are used in the procedure boxes, preserve logic from the //true// branches and remove the //else// logic from the images in the calibrator. See [[howtos:Selective calibration - excluding some of a simulator from calibration]] | ||
creating_a_calibration_diagram.1289578254.txt.gz ยท Last modified: 2010/11/12 16:10 by marcus.williams
Page Tools
