This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
howtos:toolcoding:rachetinginview [2013/06/04 12:25] shona.weldon created |
howtos:toolcoding:rachetinginview [2013/06/04 18:14] (current) shona.weldon |
||
---|---|---|---|
Line 2: | Line 2: | ||
When a view is run the user often interacts with the view and it would be good to save those answers for subsequent runs. In addition, these answers will be specific to a project and you only want to reuse those answers for the project at hand. | When a view is run the user often interacts with the view and it would be good to save those answers for subsequent runs. In addition, these answers will be specific to a project and you only want to reuse those answers for the project at hand. | ||
+ | If the user wants to read or write to disk they will specify a project under which their data will be saved | ||
+ | |||
+ | The view defines 4 ways for the user of a view to specify their settings for this run of the view: | ||
+ | * "manual entry without save (default)" | ||
+ | * "manual entry with save for next time" | ||
+ | * "import data from previous run" | ||
+ | * "import data from previous run AND allow change" | ||
===== Background Info ===== | ===== Background Info ===== | ||
* [[howtos:toolcoding:projectNamesDefn|Defining a project for the project list]] | * [[howtos:toolcoding:projectNamesDefn|Defining a project for the project list]] | ||
+ | * [[https://www.whatiftechnologies.com/doku.php?id=how_tos#view_writing|Data storing in viewData]] - see the bullet about viewData and it's location | ||
+ | * [[howtos:toolcoding:viewInformants|view specific informants]] | ||
+ | * [[howtos:toolcoding:getProjectExportPath|Getting project specific paths]] | ||
+ | |||
+ | ===== Building the Rachet view ===== | ||
+ | |||
+ | Check out the example in /models/caness/V5/views/sim/residential/resThermCondEnrCode_v2.t | ||
+ | |||