Differences

This shows you the differences between two versions of the page.

--- howtos:typicalerrors [2011/04/21 16:09]
chris.strashok
+++ howtos:typicalerrors [2011/08/30 18:28] (current)
marcus.williams
@@ Line 9: / Line 9: @@
 Ensure that the names of the variables entering the simulator diagram from the calibrator are the same. Also ensure that the simulator variable is bound to the correct calibrator variable by examining the History tab in the Variable Information view.
-===== seek error when saving first sim scenario =====
+===== Linking error in SAMM (UpdInVarRefCnt)  =====
-Here's a screenshot of the type of error message you may see:
+Here are screenshots of the errors message you may see:
 {{:howtos:errmsg.jpg|}}
+{{:howtos:updinvarrefcnt_error2.png|}}
 That usually means you've got an output in the calibrator linked to more than one input in the simulator. Here are some things to check:
@@ Line 20: / Line 22: @@
     * check the .v file for the calculator to make sure the variable is marked correctly as an input
     * make sure that it is an output in the calibrator mapping to the input in the simulator
+===== dimensional analysis tool error =====
+TOOL error during dimensional analysis:
+<file>
+= tool: Can't open file: ink
+TOOL: execution error
+</file>
+Possible cause:
+You are trying to run dimensional analysis backwards when there is no calibrator structure in place.
+Remember you do not need to run the calculators backwards when you have a simulation framework on its own, or for the calibration framework.

whatIf? Wiki