This is an old revision of the document!
When you see the following message,
the variables between the calibrator and the simulation are not linked up properly. This is usually caused when the name of a variable is changed in the calibrator and is not updated in the simulator.
Ensure that the names of the variables entering the simulator diagram from the calibrator are the same. Also ensure that the simulator variable is bound to the correct calibrator variable by examining the History tab in the Variable Information view.
Here's a screenshot of the type of error message you may see:
That usually means you've got an output in the calibrator linked to more than one input in the simulator. Here are some things to check:
When you see the following message in the Documenter TOOL console,
= tool: Can't open file: ink
TOOL: execution error
you are trying to run the calculators backwards when there is no calibrator structure in place.
Remember you do not need to run the calculators backwards when you have a simulation framework on its own or for the calibration framework.